News Digest:Dredge pump for sale - fourteen ways to monitor sand dredge pump operation. Dredge pump for sale, China Do Pump, is a manufacturer of dredge pump, sand pump, electric submersible sand pump, hydraulic submersible dredge pump, on board dredge pump, ladder d
Dredge pump for sale - fourteen ways to monitor sand dredge pump operation
Dredge pump for sale, China Do Pump, is a manufacturer of dredge pump, sand pump, electric submersible sand pump, hydraulic submersible dredge pump, on board dredge pump, ladder dredge pump, slurry pump, dredging equipment. More than that, dredge pump for sale, China Do Pump is also a dredging solution provider, such as how to select a dredging pump, how a dredge pump works, how to monitor a sand dredge pump operation. Here dredge pump for sale, China Do pump is shown fourteen ways to monitor sand dredge pump operation.
1. Before the sand pump is operated, the pool should be filled with clean water, open the pump inlet valve, and close the pump outlet valve.
2, then start the pump, slowly open the pump outlet valve after the pump starts
3, at the same time according to the amount of sand into the pool
4. The size and speed of the pump outlet valve opening should be mastered by the pump not vibrating and the motor not exceeding the rated current until the page can be stabilized at 0.5-1 meters above the inlet pipe.
5. Regularly check and adjust the packing gland or replace the packing in time.
6, pay attention to check the bearing operation, not into the mine operation, such as bearing into the mine must stop immediately for cleaning and oil change
7, the bearing temperature must not exceed 75 ° C
8. If the bearing starts to run, the bearing can be stopped and the bearing is cooled to run again. If it is still hot, it must be stopped.
9. Adjust the ore supply or the outlet valve of the pump or the pump in time. In any case, the pump is forcibly pumped to cause vibration of the pump.
10. It is forbidden to enter any pump material into the pump to prevent blockage or damage to the pump lining.
11. Refuel in time according to the oil level of the pump
12. Check if the water seal water pressure is normal, whether it is blocked, whether the water volume is sufficient, and whether the water quality is clean.
13. Check the lubricating oil level of each part, whether the oil temperature is normal, the lubricating oil should be clear, and the oil temperature should not exceed 50 degrees.
14. Pay attention to observe whether the working current of the motor is normal, and whether the motor has abnormal noise.
On above, dredge pump for sale, China Do Pump explains fourteen ways to monitor sand dredge pump operation, for more information about dredge pump for sale or dredging pump solutions, contact China Do Pump at info@dopumpgroup.com or call us at +8615031104888.
