News Digest:How to choose a sand pump when large particles in dredging environment?, dredge pump for sale, China sand pump, submersible slurry pump parts. Sand Pump is renamed as dredge pump, dredging pump which is a part of dredging equipment either installed on the
How to choose a sand pump when large particles in dredging environment?
Sand Pump is renamed as dredge pump, dredging pump which is a part of dredging equipment either installed on the dredger, submerged into water, or boostered on land. In this chapter, China Do Pump shares knowledge with How to choose a sand pump when large particles in dredging environment. Dredge pump are divided with many different types, such as submersible dredge pump, on board sand pump, ladder pump, double-walled dredge pump, single-walled dredge pump, electric submersible dredge pump, hydraulic submersible dredge pump, dredge pump coupled with diesel engine, dredge pump belled with diesel engine etc.
1. When selecting a sand pump, consider choosing a good flow capacity. Use a pump with a large capacity to pump the stones as much as possible. If the stone is not pumped up, it will hinder the sand pumping. For the environment with many pebbles, China Do Pump recommends customers to choose >> large particle sand pump
2. Support high-pressure water pump, the flow rate should be as large as possible. The lift is no less than 50 meters, and the powerful high-pressure water can flush more small stones and pump them away.
3. The suction pump faucet should increase the counterweight to avoid the faucet falling due to the backlash of the high pressure water by the stone, causing the concentration to be too low.
4. The suction faucet filter grid should not be set too small. The interval should be set reasonably in combination with the maximum overcurrent capability of the sand pump. Avoid setting too small and causing large particles to adhere to the filter screen, affecting the sand.
5. The supporting power needs to be one or two levels higher than the standard supporting power. When the large stones are more, the specific gravity of the medium rises. Under other factors, the power required may be greater. The large matching power helps the stable transportation of large stones and large particles, and the pipes are not easy to be deposited.
6. As far as possible, the transmission pipe should be made of ultra-high molecular polyethylene pipe with low resistance. Other iron pipes and steel pipes have high resistance and are not recommended. When laying the sand pipe, it should be kept as gentle as possible. The pipe that is floating up and down is easy to cause the medium in the pipe to settle during the transportation, which causes the pipe to be blocked.
7. The sand with many stones should be selected as the sand pump with wear-resistant alloy material. When the stone is too much, the wear of the sand pump is very large, far exceeding the wear of the yellow sand and white sand. The frequent replacement of the parts will cause working hours. Delay. The economical conditions allow, the wear-resistant alloy sand pump as an option.
For more How to choose a sand pump when large particles in dredging environment, contact dredge pump for sale - China Do Pump at info@dopumpgroup.cocm or call us at +8615031104888.
