News Digest:Why the submersible sand pump motor is burned out, dredge pump for sale, china sand pump, submersible slurry pump parts, Dredging pump solutions-Why the submersible sand pump motor is burned out.China Do Pump is a manufacturer of sand pump. dredge pump, e
Why the submersible sand pump motor is burned out
Dredging pump solutions-Why the submersible sand pump motor is burned out.China Do Pump is a manufacturer of sand pump. dredge pump, electric submersible sand pump and hydraulic submersible dredge pump with relative dredging equipment, such as on board dredge pump, ladder dredge pump, booster sand pump.
The submersible sand pump is a pump that pumps the entire pump in the water for easy use and high efficiency! Today, China Do Pump introduce Why the submersible sand pump motor is burned out? The following is a brief introduction to the cause of the burnout of the submersible sand pump motor:
1. The grounding wire is connected to the wrong power supply. The cable of the submersible sand pump has four cores. If you do not pay attention to it when using it, it is easy to connect the grounding wire as a power cord.
2. The mechanical seal of the diving pump is causing water leakage. It is necessary to check the insulation resistance of the submersible sand pump frequently during use. When the insulation resistance value is lowered, timely maintenance measures can be taken to effectively avoid motor burnout.
3. The cable of the diving pump is damaged, which causes the motor room to enter the water. Always check the insulation resistance of the sand pump.
4. The impeller pumping pump impeller is stuck. When the impeller is stuck and does not move, the current increases more than the rated value. After a long time, the stator winding of the submersible sand pump will burn off quickly.
5. Both ends of the stator winding touch the outer casing and the winding penetrates to the ground.
6. The diving pump is “on” and “stopped” too frequently.
7. The dehydration operation time of the submersible sand pump is too long. The dehydration operation time of the submersible sand pump can only be about 1 minute, the time is too long, and the heat dissipation causes the temperature to rise.
The above is the general reason for the burnout of the submersible sand pump motor. Everyone can pay attention when using it.
For more dredging pump solutions related to Why the submersible sand pump motor is burned out, contact Sand Pump Manufacturer China Do Pump at info@dopumpgroup.com or call us at +8615031104888.
