China Slurry Pump - How to assemble FAM type base
How to assemble FAM type basel of China slurry pump, here is an article written by China Do Pump, a China Slurry Pump Solution provider, including How to assemble FAM type base, China Slurry Pump - gland Seal Assembly, China Slurry Pump Parts - Bearing assembly test instructions, How to Maintain China slurry pump - Bearing lubrication, How to Maintain China slurry pump - Adjust slurry pump impeller, how to maitain China slurry pump shaft seal?, What are the steps when China slurry pump stops?, What are the Reasons cause China slurry pump operate failure? , What are the inspections before China Slurry Pump starts, what are the features of China slurry pump, what are the type of China slurry pump, how to select a China slurry pump, for any question related to China slurry pump, contact China Do Pump at info@dopumpgroup.com or call us at +8615031104888
China Slurry Pump - How to assemble FAM type base
1. Install the shaft O-ring (China slurry pump parts code G109) on the labyrinth sleeve and push it to the shoulder.
2. Install the shaft spacer (China slurry pump parts code FAM117) on the shaft (China slurry pump parts code 073).
3. Install the shaft sleeve (China slurry pump parts code G075) to the end face of the retaining sleeve and the labyrinth sleeve.
4. Install the water seal ring 063 on the shaft sleeve, and then install the neck ring (China slurry pump parts code 067) to make them fit properly, and push the two to the bearing body.
5. The lifting beam 310 of the pressure-reducing cover bears the corresponding boss of the expeller ring (Chinaslurry pump parts code 029) with three lifting screws. The oil injection hole on the pressure-reducing cover must be in line with the suspension beam.
6. Lift the decompression cover by lifting the lifting beam, install it in the pump body, and gently tap it into place with a wooden hammer.
7. After assembling, use the following methods to assemble the stuffing box in the pressure reducing cover.
a) Put the neck ring (China slurry pump parts code 067) into the stop of the pressure reducing cover to hold it.
b) Take a piece of packing ring (China slurry pump parts code 111) of appropriate length, install it in a stuffing box, and press the packing pad tightly.
c). Install the lantern ring (China slurry pump parts code 063) to compact the first filler.
d), install another packing, almost fill the packing box (the packing interface should be staggered).
e) Put the packing gland (China slurry pump parts code 044) on the bushing, tighten it with the gland clamp bolt (China slurry pump parts code 126), and press the decompression cover in the direction of the decompression cover to press the packing, then insert the gland bolt (China slurry pump parts code 045) and tighten the nut ).
f). Install the second shaft (China slurry pump parts code O-ring 109) into the stop at the end face of the sleeve.
8. Install the expeller ring (China slurry pump parts code 029) on the shaft, slide it towards the shaft sleeve and compress the shaft sleeve.
9. Lubricate the shaft thread.
China Do Pump is a manufacturer of slurry pump, sand pump. dredge pump, electric submersible sand pump and hydraulic submersible dredge pump with relative dredging equipment.For more China slurry pump solutions related to China Slurry Pump - How to assemble FAM type base, contact Sand Pump Manufacturer China Do Pump at info@dopumpgroup.com or call us at +8615031104888.
